The drain is the work-horse of all plumbing schemes. A drain is required to allow the passage and emptying of the flushed water and wastewater into the septic system. No matter how clean you keep your drains, or how vigilant you are about what’s going down on them at one time or another, they will get stuck. They can get clogged with hair, waste material, food particles and grease built up. You may use a home-drain cleaning mixture of vinegar and baking soda daily to make them run clear and clean. Should not use harmful chemicals when the drain gets clogged but rather reach for a plunger to try and unstop the drain. You should use a plumbing snake for drains that are gravely clogged.Interested readers can find more information about them at K2 Plumbing-Hollywood Plumbing
Using the above listed mixture each month is one of the best drain cleaning practices for avoiding clogs and providing an open clean drain. You will need to pour a cup of baking soda one at a time into each drain, followed by a cup of hot vinegar and three to four quarters of extremely hot water. Those three factors will cause a chemical reaction that will force any debris into the drain trap that may create a clog. The vinegar ‘s acidic properties will bind some of the harmful bacteria that may be in the pipes and the baking soda will produce a scent.
If you have a clogged drain the plunger is the ideal drain cleaning tool. When you put the plunger in the drain over the hold and pump it vigorously several times it will remove most obstructed drains. It needs to have strong suction before a plunger will work very well. If there is a sink with overflow holes in the clogged drain then you can cover them with a wet rag. You will fill the sink with approximately two inches of water to allow for better suction and cover the plunger if there is little or no water in the sink already.
When you don’t work with a plunger you can use plunger snake to clean the drain. It is flexible long steel cable, wrapped around the crank. To effectively use this tool you will need to use a wrench to remove the drain trap. It is situated underneath the sink. You must then insert the snake into the drain pipe which leads to the sewer system. You’ll need to transform it in a motion in clockwise direction. By turning it the steel cable’s narrow coils will grasp debris and hair as it turns.